Emerson VCR872 - Setting the Clock to the Present Time

t
SETTING THE CLOCK TO THE PRESENT
TIME
THIS CLOCK IS BASED ON 1 2-HOUR DISPLAY. [ AM 1 2:00 ] INDICATES MIDNIGHT;
[ PM 12:00 ] MIDDAY AND [ PM 3:00 ] 3 O ’ CLOCK IN THE AFTERNOON.
INCASE OF CLOCK DISPLAY FLASHING
FOR EXAMPLE
setting the clock MON 9:05 PM'.
(The present time is 9:04 on Monday evening.)
NOTE
PREPARATION
• VCR POWER switch is on.
• Make sure the TIMER REC
switch is off.
• Open the compartment door,
(after setting the clock,
close the door)
_____ _________-
After a power failure or disconnection of the power plug, all programmed recording settings and
time display will be lost and will be shown by the 12:00 time display upon resumption of power.
In this case reset the present time and then program recording. Since built-in circuit continues
to work for 30 minutes, the timer display indicates the present time if the power resumes within
30 minutes.
Press the CLOCK SET button
when the present time reaches
(SU — MO — TU.„)
F Y 5
(+)(00 — 01 — 02 — 03..)
(-)(00 — 59 — 58 — 57..)
9:05 ’ 00 ” .
The clock will start from "00"
seconds, however, the sec 
onds will not be displayed.
HOW TO RESET THE CLOCK
When the START button is
pressed quickly and
repeatedly, the indication will
change in 1 -minute steps.
When it is kept pressed, the
indication will change in 10-
minute steps.
□
}
is set, press the
to adjust the day.
Press the START(+)(4) After the present time
or (-) button to
1) Press the CLOCK
SET button.
The clock display
starts to flash.
adjust the clock.
- 12 —
CLOCK SET button.