Emerson XM678D - Page 63

MODBUS Termination Blocks Default Parameter Map • 55
dAo 0.0
Delay of
temperature alarm
at start
-up
0.0 to 24h00m
in
After powering the device: time interval
between the detec
tion of the
temperature alarm condit
ion and the
alarm signaling.
Format: hou
rs.10min 
Resolu
tion: 10min
EdA 30
Alarm delay at the
end of defrost
0 to 255mi
n
At the end of the defrost cycle: time
interval between the detecti
on of the
temperature alarm co
ndition and the
alarm signaling.
dot 15
Temperature alarm
exclusion
after door
open
0 to 255min -
Sti nU
Stop regulation
interv
al
0.0 to 24h00min; nU
After regulating continuously for Sti
time, the valve closes
for Std time to
prevent ice from forming.
Format: hou
rs.10min 
Resolu
tion: 10min
Std 1 Stop duration 1 to 255min
Defines the stop regulation time after
Sti. During t
his interval, the display
shows StP message.
tbA n
Silencing alarm
relay by pressing a
key
n; Y -
O
UTPUT CONFIGURATION
OA1 CPr
Relay on terminals
11-1
2 configuration
nU; CPr; dEF; FAn; ALr;
LiG; AUS; db; onF; AC
nU = n
ot used; CPr = compressor/
val
ve; dEF = defrost; FAn = Fan; 
ALr = Alarm; LiG = L
ight; 
AUS = auxi
liary; db =
heater for neutral
zone (not available with CrE = Y); 
onF = ON/OFF; AC
= anti-swea
t; 
E3r: solenoid valve for EX3 or for
mechanical
solenoid valve
OA6 AUS
Relay on terminals
17-1
8 configuration
nU; CPr; dEF;
FAn; ALr; LiG;
AUS; db; onF; AC
nU = n
ot used; CPr = compressor /
val
ve; dEF = defrost;
FAn =
Fan; ALr = A
larm; LiG = Light;
AUS = auxiliary; db = heater for neutral
zone (not available with CrE = Y);
onF =
ON/OFF; AC = anti-sw
eat; 
E3r: solenoid valve for EX3 or for
mechanical
solenoid valve
OA7 nU Relay on terminals
nU; CPr; dEF; FAn; ALr;
LiG; AUS; db; on
F; AC
nU = n
ot used; CPr = compressor/
val
ve; dEF = defrost; FAn = Fan; 
ALr = Alarm; LiG = L
ight; 
AUS = auxi
liary; db =
heater for neutral
zone (not available with CrE = Y); 
onF = ON/OFF; AC
= anti-swea
t; 
E3r: solenoid valve for EX3 or for
mechanical
solenoid valve
Label Value Description Range Notes
Table 24-1 - Default Parameter Map