64 • XM678D I&O Manual 026-1219 Rev 3
9. Press to enter the Status screen.
10. Press to open Actions Menu.
11. Highlight 9. Applications Commands and press
.
12. Scroll down using the down arrow key and
high
light Send E2 Cfg to Device. The Send E2
Cfg to Device command sends the backup
XM678D configuration that is in the E2 to the
XM678D controller.
13. Press
to apply the command.
14. The E2 XM678D configuration will be sent to
the n
ew XM678D. Make sure to check the
parameters and functionality on the device.
15. Reboot the XM678D controller after five (5)
minutes. If P5 and P6 are flashing, resend the E2
Cfg to Device and reboot after five (5) minutes.
Figure 24-9 - Device Status Screen
Figure 24-10 - Actions Menu
Figure 24-11 - Applications Command
To Next Page
Loading...
