2.1 Connecting the router wired
1. Turn off your computer.
2. Connect the router to a wall outlet using the supplied power adapter.
3. Connect the supplied UTP network cable to the ‘WAN’ port of the router.
4. Connect the other end of the UTP network cable to the ‘LAN’ port of your cable
modem.
5. Connect a UTP network cable to one of the four ‘LAN’ ports of your router.
6. Connect the other end of the UTP network cable to the network adapter in your
computer.
Do I have a proper network connection? Turn on the computer and verify if the LED on
the router, corresponding with the LAN-port to which you connected the UTP
networking cable, is lit. The LED on the network adapter of your computer should also
be lit.
2.2 Configuring the router for connection with the Internet
via DHCP
Before you can configure the router for a connection with the Internet, you will first
need to connect to the router. Follow the instructions below to connect to the router.
1. Launch your internet web browser on your computer and type http://192.168.8.1 in
your browsers address bar.
2. Please enter the User Name: admin and Password: admin and then click on “OK”
button.
3. Click on “Setup Wizard”.
4. Please make sure WAN Access Type “DHCP Client” is selected and press “Next”
To Next Page
Loading...