Emotiontek MCU 2 Axis - Page 174

- 167 -
Chapter 9. Standard Input/ Output Signal
X0.4
M50.4
X0.5
M80.7
8) Servo Off Function
If the
basic parameter P46 (Servo On) is selected, you can control the Servo On output contact
Y0.2, Y0.3.
Turn OFF the servo when X0.4 is‘1’.
LOAD X0.4
OUT M94.C ÆM94.C[SOF1] 1
st
axis Servo Off commanding bit
OUT M94.D ÆM94.D[SOF2] 2
nd
axis Servo Off commanding bit
한 블록
실행
One block
execution
One block
execution
One block
execution
One block
execution
One block
execution