Empatica E4 - Attaching the Band

22
empaca
©
2015
Aaching the band
Follow these steps to aach the band:
1 - Slide loop towards the case.
2 - Place the E4 top-down on a surface.
5 - Wrap the band over snaps and ghten.
6 - To secure, connect one snap at a me.
7 - If too ght, loosen by one snap.
3 - Wrap the band around the wrist.
4 - Line up the snaps under the middle and ring ngers.
8 - The E4 should t snugly above the wrist joint.
9 - Press the buon to power on the E4.