emz smart Sol - Commissioning Mode: Flow and Heat Quantity Setup; Volume Flow Measurement Setup

Page 49
0.4 Inputs
04. 07. 2015 09:19
TS4
HE control signal
---
Sensor
Next
0.4.1 Volume ow
04. 07. 2015 09:20
Impeller 1
Heat quantities
---
Next
0.4.1 Volume ow
04. 07. 2015 09:20
Impeller 1
Heat quantities
TS3
Next
Continue with „Sensors“ once all assigned
inputs have been allocated.
If the volume ow is measured with an impel-
ler, „Impeller 1“ must be selected.
COMMISSIONING MODE
Assign the appropriate interface and then ...