Page 81
1.10 Service Wizard
04. 07. 2015 10:33
Please replace
the cable.
Exit
1.10 Service Wizard
04. 07. 2015 10:33
Could you detect
a short-circuit /
cable break?
Yes
No
1.10 Service Wizard
04. 07. 2015 10:34
Possible reasons:
Cable/connection
Sensor
Exit
MALFUNCTION
If the cause of the malfunction
has not yet been determined,
troubleshooting can be continued.
Continue with ›No‹.
Select all the sources of malfunctions
listed, and conrm via ›OK‹.
Repair information appears.
Perform the appropriate repair work.
Exit the ›Service Wizard‹
by pressing ›Exit‹.
To Next Page
Loading...
