EL – Owner’s Manual – Rev.00 – September 2021 5
Additional safety for the electrolyser
The following rules should always be observed. It is the operator’s responsibility to ensure that every
person, working with the device is following these rules:
1. Do not attach filled tanks or other equipment with pressures higher than the device’s
maximum outlet pressure to the H
2
outlet of the device.
2. Do not provide water which does not meet the minimum purity requirements.
3. Do not provide water with a pressure higher than the maximum allowed pressure.
4. Make sure that the H
2
purge line and the O2 vent line are never obstructed.
Additional safety for the dryer
The following rules should always be observed. It is the operator’s responsibility to ensure that every
person working with the device is following these rules:
1. Do not attach filled tanks or other equipment with pressures higher than the device’s
maximum outlet pressure to the H
2
outlet of the device.
2. Do not attach hydrogen sources other than the electrolysers specified by Enapter.
3. Make sure that the H
2
purge line is never obstructed.
To Next Page
Loading...
