Enapter EL - Appendix IV. LED States; Appendix V. Error Codes

Version
Document Title
Release Date
00
EL – Owner’s Manual
2021-09-22
EL – Owner’s Manual – Rev.00 – September 2021 39
Appendix IV. LED States
EL2.1 LEDs
EL2.1 NB DC LEDs
The three LEDs located next to the right handle on the front panel and help to indicate the device
status and operating condition.
During normal operation, the LEDs indicate the status of the device. Please visit the Handbook for
the status LED indication of the electrolyser and the dryer.
Appendix V. Error Codes
Here you can find a list of all the errors that can be triggered while using the electrolyser. The list
covers all firmware versions.
Check, which firmware is installed on your device and then chose “Modbus TCP Communication
Interface” and then “Warning, Error and Fatal Error Codes” to access all warning and errors. E.g. the
warnings and errors for the firmware version 1.6.1 can be found here.
For the warnings and errors, which can appear while using the dryer, use this list.