EL – Owner’s Manual – Rev.00 – September 2021 26
INITIAL OPERATION OF THE ELECTROLYSER
Preparing for H
2
Production
Now that the device is connected, here is what to do next to get it running.
Pairing the device to the cloud
It is time to power on the device for the first time. Switch the breaker at the top of the front panel in
the upper position to switch the device on.
Using the Enapter app, add your device to a site. For detailed information on this, please refer to the
mobile application handbook.
1. To start using the application, you need an account in the Enapter Cloud. If you already have
an account, simply skip this step.
a. To create an account, click on the create account button of the first screen.
2. After logging in on the Enapter app, create a site – a virtual environment which will house all
the telemetries collected from the devices connected to the cloud via UCMs (Universal
Communication Modules).
3. Add the device to the site by scanning the QR code located on the front panel.
Manual refilling of electrolyte
Your device is now ready to be commissioned for its first use. You will notice that the device you have
just successfully paired to the cloud has started in maintenance mode and is prompting you to perform
the first-time filling.
To prepare the electrolyser for operation, before demineralised water is added automatically, it must
be filled with the electrolyte which is included in the shipment. If it is not included, it can typically be
procured or purchased locally. Please refer to Appendix II below.
Warning! Refer to the Material Safety Data Sheet (MSDS) of all chemicals
used, before handling them. All persons using, preparing, and filling the
electrolyte into the device must be informed about any potential hazards
involved with their activities.
To Next Page
Loading...