EL – Owner’s Manual – Rev.00 – September 2021 10
INSTALLATION OF THE ELECTROLYSER
Any person working on the device must be familiar with the hazards and risks associated with
installing, commissioning, and running it.
UNPACKING
The device has been carefully inspected and tested before shipping. Visual checks for damage and
functional tests should be performed upon receipt.
Please do not dispose the original shipping materials. Enapter will not accept devices if they are
returned without the original shipping boxes or equivalents for a safe transport. In case that you
cannot keep the shipping boxes, please recycle responsibly.
Attention! If any damage has occurred during transport, please report this
immediately to the shipping agent and supplier. Afterwards, the device
should be returned according to the shipping instructions provided in this
manual, in the section “Transport, Maintenance and Recycling”.
Warning!
Never lift the device out of the packaging alone. The device weights over
50 kg. Please see the datasheet for more details.
Use lifting aids if available.
Due to their weight and size, it is recommended to use a pallet cart or similar
devices to manoeuvre the box upon delivery.
If the box must be lifted somewhere, always lift with at least two persons.
TOOLS, MATERIAL AND ACCESSORIES REQUIRED
The following tools, equipment, and material are needed to connect the device successfully. Ensure
the material chosen for this task is compatible with hydrogen operation.
Tools
• 9/16” combination wrench
• 5/8” combination wrench
• Plastic pipe cutter
• Slotted screwdriver
• Stainless steel pipe cutter
• ¼” tube bender
To Next Page
Loading...