EL – Owner’s Manual – Rev.00 – September 2021 7
as cut resistant gloves, safety shoes, protective goggles, etc. depending on
the activity.
Clear the area of work before starting to mount the device.
The device is heavy and must be lifted by at least 2 people – plan around this
and allow ample space to move around.
Do not lift the device over your head.
Caution!
During handling of the device, be cautious and use the handles on the device
to minimise the mechanical risks, such as:
• Impacts and crushing injuries due to uncontrolled movements of the
load.
• Dropping the device, causing crushing injuries
• Loss of stability, leading to entanglements and other injuries.
The packaging/device must be handled by at least two people.
Electrical hazards
Do not touch the antenna when the device is powered on. The device poses no special electrical
hazards, if the following instructions on safety measures are observed and the Electrical Connection
Guide below is applied correctly:
Caution!
• Handle the electrical installation with care. Ensure that the power
plug is fastened correctly into the socket to avoid any loosening of
the wiring.
• Use only the supply voltage specified on the rear of the device.
• Do not short-circuit inputs and outputs.
• Do not reverse the polarity of inputs and outputs.
• Do not insert any mechanical parts, especially metal parts, into the
device through the ventilation slots or other openings.
• Do not use liquids near the device.
• Never use the device if any part of it has been immersed in water.
• Do not touch the antenna when the device is powered on, ensure
you are electrostatically discharged when mounting/dismounting
the antenna.
WARNING!
Always turn off the power supply when the device is being cleaned,
maintained, or transported.
Any servicing, other than cleaning and routine user maintenance, must be
performed by trained, Enapter-endorsed technicians.
To Next Page
Loading...
