EL – Owner’s Manual – Rev.00 – September 2021 18
Water Inlet Connection Guide (H
2
O IN)
The water inlet connector is a push-fit bulkhead, for an outside pipe diameter of 8 mm. This inlet port
is used for the automatic refilling of demineralised water from a pressurised source.
EL2.1 NB DC H2O IN and O2 VENT
Warning!
Ensure water pressure on the input line never exceeds the maximum allowed
pressure. This can cause irreparable damage to the device and create significant
leakages. Enapter is not responsible for any damage or injury resulting from the
misuse of the device.
Attention!
Ensure your water input quality is sufficient. Demineralised water with a higher
conductivity than stated in the datasheet will irremediably damage the stack. The
same applies for particles and debris in the demineralised water. Install filters at
the water inlet of the device and clean them regularly to ensure that the water is
free of particles. If a device is damaged from using low-quality water, Enapter is not
responsible for any damage caused.
Flush all water pipes with demineralised water before connecting your device to ensure no debris is
in the lines. Then connect the “H
2
O IN” port located at the top left of the front panel directly to your
water supply.
To Next Page
Loading...
