Enapter Electrolyser - Page 8

VERSION
DOCUMENT TITLE
RELEASE DATE
03
EL – Owner’s Manual
2022-04-29
EL – Owner’s Manual – Rev.04 – April 2022 2
This is a draft manual, technical specifications are subject to change
Power Supply
200 V – 240 V (AC), 50/60 Hz
48 V – 60 V (DC)
Maximum Heat Dissipation
1,3 kW
Circuit Breaker
C13
Dimensions (W x H x D)
482 mm x 266 mm x 635 mm
Space inside cabinet
6 U
Weight
41 kg (empty)
1
37 kg (empty)
2
Control System Included
EMS
Communications
Wi-Fi
- 802.11a/b/g/n (2.4 GHz only)
- 802.12 WEP, WPA, WPA2 Personal (Pre-shared key)
- Wi-Fi client isolation must be disabled
Bluetooth
Modbus TCP via Ethernet
Remote Control
Enapter Cloud Service, Enapter App, Modbus TCP, Safety chain
(dry contact)
Safety
Maximum H
2
contained within
20 NL
Conformity
CE certified according to the machine directive 2006/42/CE
S.E.P. Classified as per 2014/68/EU PED
ISO 12100
IEC 61000-6-3
IEC 61000-6-2
ISO 13849
IEC 61010-1
IEC 61508
ISO 22734 ready
ASME B31:12
Noise level at 1 m
≈ 65 dB
Ventilation and Safety
Recommendation
Indoor: Ventilation depends on room size, Hydrogen detection
system with a safety circuit is recommended
Outdoor: Protect from outside environmental influences, if
integrated into a cabinet. Ensure the safety concept of each
integrated module is respected.
Environmental
Operating Conditions
5 °C to 45 °C, up to 95 % humidity, non-condensing
1
5 °C to 50 °C, up to 95 % humidity, non-condensing
2
Storage Conditions
IP Rating
IP 20
Interfaces
H
2
Outlet
¼” bspp female port
O
2
Vent Outlet
⅜” bspp female port
H
2
Vent Outlet
¼” bspp female port
H
2
O Inlet
10 mm push-fit female bulkhead connector
Fill / Drain Port
CPC quick connector 10 mm