OPERATION
Setting Single Exposure Time
To deliver a single exposure to the target tissue:
1. Using the Laser Duration push button, adjust the exposure time to the
desired setting. The selected exposure time will appear in the Laser Duration
display.
2. Select the Enable mode with the Enable push button as indicated by the
Enable status indicator. Each depression of the Foot Switch will deliver only
one exposure at the selected exposure time. The yellow display will count
down the exposure time.
Between Patient Treatments and System Turn Off
When treatment is complete or is to be interrupted:
1. Remove the key from the rear panel.
2. If several patients are to be treated, always return all Front Panel
controls to their minimum settings. Disinfection and sterilization
procedures are necessary and required between each surgical operation. The
E2 Microprobe¥ should be de-energized for cleaning.
3. When all treatments are concluded, turn the Key switch to the
“O” (off) position. Remove the key to prevent unauthorized use
of the laser system.
To Next Page