BEGINNING
Precautions
To prevent fire or shock hazard, do not expose the unit to rain or
moisture.
Dangerously high voltages are present inside the E2 Microprobe¥. Do not open
the cabinet. Refer servicing to qualified personnel only.
In the event of a malfunction or when maintenance is necessary, consult:
Endo Optiks
39 Sycamore Ave., Little Silver, NJ, USA.
Tel: 001 732 530 6762, Fax: 001 732 530 5344
Email: info@endooptiks.com
On safety
x Operate the unit on the designated AC voltage only.
x The Fuse Replacement Label indicates operating voltage and is located
adjacent to the mains fuse holder in the rear of the cabinet.
x Should any solid object or liquid fall in, unplug the unit and have it checked
by qualified personnel before operating it any further.
x To disconnect the AC power cord, pull it out by grasping the plug, never pull
the cord itself.
x The outlet shall be installed near the equipment and shall be easily
accessible.
Warning
This equipment/system is intended for use by healthcare professionals only. This
equipment/system may cause radio interference or may disrupt the operation of
nearby equipment. It may be necessary to take mitigation measures, such as
reorienting or relocating the E2 Microprobe or shielding the location.
Endoscopes and Probes
This device is intended to be used in conjunction with Endo Optiks endoscopes
and probes ONLY and to assure safety should not be connected or used with
any other devices.
Disconnect the endoscope from the system by grasping the connectors only. Do
not grasp or bend the endoscope jacketing for this may break the glass fibers
that are enclosed within the jacketing.
To Next Page