CAUTION: The heat generated by the light source varies and can be hot causing
the light connector, on the endoscope, to become hot. To prevent injury to the
operator the light intensity should be turned down so the connector can cool
before removing it from the system.
On installation
x The E2 MicroProbe¥ should be used in a Hospital or Clinical setting only. It
should be used indoors only under the environmental conditions stated on
Page 36 of this document.
x Allow adequate air circulation to prevent internal heat build-up.
x Do not place the unit on surfaces (rugs, blankets, etc.) or near materials
(curtains, draperies) that may block the ventilation holes.
x Do not install the unit in a location near heat sources such as radiators or
air ducts, or in a place subject to direct sunlight, excessive dust, mechanical
vibration or shock.
On cleaning
To keep the unit looking brand-new, periodically clean it with a mild detergent
solution. Never use strong solvents such as thinner or benzine, or abrasive
cleansers since they will damage the cabinet. As a safety precaution, unplug
the unit before cleaning it.
On sterilization before use
WARNING - The endoscopes and probes must be sterilized before use.
Please refer to the instructions provided with each device.
To Next Page