EasyManua.ls Logo

Endo Optiks E2 - Labels

Endo Optiks E2
47 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
Safety Agency Approvals (MET
MARK)
P/N E112374
Rear panel, bottom left, under AC
receptacle
Caution: HOT
P/N: L1009A
Front Panel, next to light connector
when 300W light installed
This symbol has been attached to the equipment or, in the case that this is not possible,
on the packaging, instruction literature and/or the guarantee sheet. By using this symbol it states
that the device has been marketed after August 13th 2005, and implies that you must separate
all of its components when possible, and dispose of them in accordance with local waste
disposal legislations.
- Because of the substances present in the equipment, an improper use or disposal of the
refuse can cause damage to human health and to the environment.
- With reference to RAEE (Registry of Electrical and Electronic Apparatuses), it is
compulsory not dispose of the equipment with normal urban refuse, arrangements
should be instigated for separate collection and disposal.
- For more detailed information about recycling of RAEE, please contact your local waste
collection body.
- In case of illicit disposal, sanctions will be levied on transgressors.
Hospital Grade Power Cord
P/N: Hospital Grade Labels
Above Power Receptacle On Rear Panel
To achieve proper grounding reliability,
a power supply plug must be fully inserted
into a receptacle marked "HOSPITAL GRADE"

Table of Contents