Need help?Do you have a question about the Endress+Hauser Ceraphant T PTC31 and is the answer not in the manual?
General| Type | Pressure switch |
|---|---|
| Measurement Principle | Piezoresistive |
| Accuracy | ±0.5% of span |
| Operating temperature | -40 to 85 °C |
| Material | Stainless steel |
| Process connection | G 1/2, 1/2 NPT |
| Protection Rating | IP67 |
| Approvals | EAC |
Specifies the intended purpose of the Ceraphant T pressure switch.
Outlines requirements for qualified personnel performing installation and operation.
Addresses explosion hazards and general safety measures during operation.
Details how to identify the device using its nameplate information.
Explains the CE mark and compliance with EC Directives.
Lists registered trademarks associated with the device.
Instructions for checking delivered goods and storage conditions.
Guidance on mounting the device for different media measurement.
Checklist to verify correct installation after mounting.
Wiring diagram and pin assignment for M12 connector versions.
Wiring diagram for devices with a valve connector.
Wiring diagrams for devices connected via cable.
Specifies the required DC supply voltage range for the device.
Details the device's current draw.
Checklist for verifying electrical connections after wiring.
Explains how to operate the device using its keys and display.
Step-by-step guide to navigating the device's menu structure.
Visual representation of the device's menu hierarchy and available settings.
Describes configuration using PC software like ReadWin or FieldCare.
Details extra functions available through PC configuration software.
Information source for ReadWin configuration software.
Information source for FieldCare configuration software.
Guidance on performing functional checks before commissioning.
Steps for configuring fundamental device parameters like units and zero point.
Configuration of hysteresis, window functions, and switch point settings.
Details on switching characteristics, switch points, and delays for outputs.
Configuration of locking codes, reset functions, and revision counters.
Guidelines for cleaning the device exterior safely and effectively.
Describes available process connection types for the PTC31 and PTP31/PTP35 models.
Instructions on how to change the adapter on PTP31 and PTP35 models.
Lists different thread adapter versions available for the PTP31 model.
Lists available clamp and hygiene adapter versions for the PTP35 model.
Details O-ring specifications and order numbers for adapter changes.
Information on welding bosses for process connections.
Details on welding bosses with metallic sealing taper.
Details on welding bosses with a sealing surface.
Information on various electrical connection types and cables.
Details on M12 plug-in jacks and connecting cables.
Information about the ReadWin configuration kit and software.
Explains device error codes (E-codes) and warning codes (W-codes).
States that repairs are not planned and directs to return procedure.
Outlines the procedure for returning the device for repair or calibration.
Guidance on the proper disposal of device components.
Explains how the release number indicates device and documentation changes.
History of device release numbers and their corresponding changes.
To Next Page