Need help?Do you have a question about the Endress+Hauser Proline t-mass 65F and is the answer not in the manual?
General| Brand | Endress+Hauser |
|---|---|
| Model | Proline t-mass 65F |
| Category | Measuring Instruments |
| Language | English |
Explains the two-level structure of groups and functions within the matrix.
Provides a visual representation of the function matrix structure and available functions.
Displays the currently measured mass flow value on the device.
Displays the currently measured corrected volume flow value.
Displays the currently measured gas ambient temperature value.
Starts the setup menu for commissioning the device.
Flowchart detailing the quick setup commissioning process.
Step-by-step guide for commission setup.
Saves or loads parameter settings from the HistoROM/T-DAT.
Selects system units for parameterization.
Selects the language for all texts, parameters, and messages.
Protects data against inadvertent change by requiring a code.
Defines a personal code number to enable programming.
Assigns a measured variable to the totalizer.
Assigns a measured variable to the current output.
Details current span, operational range, and alarm signals.
Defines the current span, operational range and alarm signals.
Assigns a value to the 0/4 mA current.
Assigns a value to the 20 mA current.
Defines the predefined state of the pulse output in case of fault.
Configures the output as pulse or frequency output.
Assigns a variable to the start value frequency (0 Hz).
Selects the output configuration for the pulse output.
Defines how the frequency output signal reacts to fluctuating variables.
Activates simulation of the frequency output.
Defines the flow at which a pulse is triggered.
Defines the number of pulses to be output during simulation.
Assigns a measured variable to the frequency output.
Assigns a variable to the end value frequency.
Defines a selectable frequency value for simulation.
Enters the maximum pulse width of the output pulses.
Activates simulation of the pulse output.
Assigns a switching function to the status input.
Defines the full scale frequency for the frequency output.
Assigns a measured variable to the pulse output.
Assigns a switching function to the relay output.
Activates simulation of the relay output.
Enables a zero point adjustment to be automatically carried out.
Interrupts flow measurement variables, sets output to zero flow.
To Next Page
