Endress+Hauser Proline t-mass 65F - Group SYSTEM UNITS

Device Functions Proline t-mass 65 3 Group SYSTEM UNITS
Endress+Hauser 9
3 Group SYSTEM UNITS
Function description SYSTEM UNITS
You can select the unit for the measured variable in this function group.
UNIT MASS FLOW Use this function to select the unit for displaying the mass flow (mass/time).
The unit you select here is also valid for:
• Current outputs
• Frequency output
• Switching points (limit value for mass flow)
• Low flow cut off
! Note!
The following units of time can be selected:
s = second, m = minute, h = hour, d = day
Options:
Metric:
gram
→ g/time unit
kilogram
→ kg/time unit
Metric ton
→ t/time unit
US:
ounce
→ oz/time unit
pound
→ lb/time unit
ton
→ ton/time unit
For arbitrary units (see function TEXT ARBITRARY MASS on Page 12)
_ _ _ _
→ _ _ _ _/s: _ _ _ _/min; _ _ _ _/h; _ _ _ _/day
Factory setting:
kg/h or US lb/h (country dependent, → Page 71 ff.)
! Note!
If you defined a unit for mass in the SPECIAL UNIT function group (see Page 12) the unit
in question is shown here.
UNIT MASS Use this function to select the unit for displaying the mass.
The unit you select here is also valid for:
• Pulse value (e.g. kg/p)
Options:
Metric
→ g; kg; t
US
→ oz; lb; ton
For free selectable units
→ _ _ _ _
(see function TEXT ARBITRARY MASS on Page 12)
Factory setting:
kg or US lb (country dependent, → Page 71 ff.)
! Note!
If you defined a unit of mass in the SPECIAL UNIT function group (see Page 12) the unit
in question is shown here.
The unit for the totalizer is independent of your choice here, it is selected separately in
the TOTALIZER group (see Page 21).