Endress+Hauser Deltapilot M FMB50 - Page 124

Appendix Cerabar M, Deltabar M, Deltapilot M / 4...20 mA HART
124 Endress+Hauser
Expert È Communication È HART output
Expert È Communication È HART input
HART date (141)
Entry
Enter the date of the last change in configuration.
Factory setting:
DD/MM/YY (date of the final test)
Parameter name Description
Primary value is (147)
Display
Indicates which measured variable is transmitted as the primary process value via the
HART protocol.
The variable displayed depends on the "measuring mode" selected:
– "Pressure" measuring mode: "Meas. pressure"
– "Level" measuring mode, "Linear" lin. mode: "Level before lin."
– "Level" measuring mode, "Activate table" lin. mode: "Tank content"
Primary value (148)
Display
Displays the primary process value.
See also "Primary value is"
Secondary val. is (149)
Display
Secondary value. Displays the assignment.
The following process values can be displayed depending on the measuring mode
selected:
– "Meas. pressure"
– "Sensor pressure"
– "Corrected press."
– "Pressure af. damp"
– "Sensor temp."
– "Level before lin."
– "Tank content"
Secondary value (150)
Display
Displays the secondary process value. See also "Secondary val. is"
Third value is (151)
Display
Third process value. Displays the assignment. See also "Secondary val. is"
Third value (152)
Display
Displays the third process value.  See also "Third val. is"
4th value is (153)
Display
4th process value. Displays the assignment.  See also "Secondary val. is"
4th value (154)
Display
Displays the 4th process value.  See also "4th value is"
Parameter name Description
HART input value (155)
Display
Displays the HART input value.
HART input stat. (179)
Display
Displays the HART input status
Bad / Uncertain / Good
Parameter name Description