Endress+Hauser Deltapilot S FMB70 - Page 183

Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus Parameter description (Local operation and FieldCare)
Endress+Hauser 183
P01-xMx7xxxx-19-xx-xx-en-011
Fig. 51: EXTENDED SETUP function group
for the "Pressure" measuring mode, → ä 183, Table 15: OPERATING MENU → SETTINGS → EXTENDED
SETUP "Pressure"
for the "Level" measuring mode, → ä 183, Table 16: OPERATING MENU → SETTINGS → EXTENDED
SETUP "Level"
for the "Flow" measuring mode, → ä 185, Table 17: OPERATING MENU → SETTINGS → EXTENDED
SETUP "Flow"
*
Parameters marked with an asterisk "*"
are not always displayed.Thedisplay
depends on the settings of other parameters,
see the following Table.
MEASURED VALUE
QUICK SETUP
BASICSETUP
DISPLAYSETTINGS
POSITION ADJUSTMENT
OPERATING MENU
EXTENDED SETUP
FlowPressure Level
TEMP. EING. UNIT
LOWFLOW CUT-OFFDENSITYUNIT
PROCESS DENSITY
TEMP. EING. UNIT TEMP. EING. UNIT
SET LRV
SET URV
ADJUST DENSITY
Table 15: OPERATING MENU → SETTINGS → EXTENDED SETUP "Pressure"
Parameter name Description
Prerequisite:
•MEASURING MODE = Pressure
Note:
• See also → ä 104ff, Section 8 "Pressure measurement (via local operation and FieldCare)".
TEMP. ENG. UNIT (318)
Selection
Select the unit for the temperature measured values.
→ See also PCB TEMPERATURE (→ ä 197) and SENSOR TEMP. (→ ä 201).
Options:
•°C
•°F
•K
•R
Factory setting:
°C
Table 16: OPERATING MENU → SETTINGS → EXTENDED SETUP "Level"
Parameter name Description
Prerequisite:
• MEASURING MODE = Level
Note:
• See also → ä 105 ff, Section 9 "Level measurement (via local operation and FieldCare)".