Endress+Hauser Flowphant T DTT31 - DTT35 Design, Dimensions for Process Connections

DTT31, DTT35
Endress+Hauser 11
DTT35 design, dimensions for
process connections
T09-DTT35xxx-06-xx-xx-yy-000
All dimensions in mm (in)
L = insertion length (see ordering information DTT35, Pos. 070)
Weight approx. 300 g (10.6 oz), depends on sensor length and process connection
Material • Process connection: AISI 316L
Surfaces in contact with process in hygienic version with surface quality R
a
≤ 0.8 μm
Coupling nut: AISI 304
• Housing: AISI 316L, with surface quality R
a
≤ 0.8 μm (31.5 μin)
O ring between housing and sensor modul: EPDM
• Electrical connection:
M12 connector: exterior AISI 316L, interior polyamide (PA)
Valve plug: outer polyamide (PA)
M12 connector: exterior 316L
Cable outer covering: polyurethane (PUR)
O ring between electrical connection and housing: FKM
DB
Ø 43.5 (1.71)
Ø 50.5 (1.99)
DL
Ø 56.5 (2.22)
Ø 64 (2.52)
LL
Ø 68 (2.68)
Ø 84 (3.31)
18 (0.71)
HL
B
Ø 100 (3.94)
Ø 82 (3.23)
Ø 61.5 (2.42)
19 (0.75)
PL
Ø 51 (2.01)
Ø 68 (2.68)
13 (0.51)
PH
Ø 39 (1.54)
Ø 56 (2.21)
13 (0.51)
(APV-Inline)
(CLAMP 1”) (CLAMP 2”)
(Varivent N)
LB
18 (0.71)
Ø 66 (2.6)
Ø 50 (1.97)
(Varivent F)
(DIN 11851)
(DIN 11851)
L
Ø 27 (1.06)
Ø 44 (1.73)
13 (0.51)
PG
(DIN 11851)
10 (0.39)
MB
L 1
SW/AF 22
37 (1.46)
G½”
Item No. Process connection versions DTT35 (see ordering information DTT35, Pos. 070)
MB Conical metal-metal for hygienic processes, G½" thread. Suitable welding boss available as an accessory.
Thread length L
1
= 14 mm (0.55 in)
DB Clamp 1" up to 1½" (ISO 2852) or DN 25 up to DN 40 (DIN 32676)
DL Clamp 2" (ISO 2852) or DN 50 (DIN 32676)
LB Varivent F DN25-32, PN 40
LL Varivent N DN40-162, PN 40
HL APV inline, DN 50, PN 40, 316L, (B = 6 x Ø8.6 bores + 2 x M8 thread)
PL DIN 11851, DN50, PN40 (including coupling nut)
PG DIN 11851, DN25, PN40 (including coupling nut)
PH DIN 11851, DN40, PN40 (including coupling nut)