Endress+Hauser Liquicap M FTI51 - Page 15

Liquicap M FTI51, FTI52 Identification
Endress+Hauser 15
KFK 10K 50 RF, PTFE >316L Flange JIS B2220
KGK 10K 80 RF, PTFE >316L Flange JIS B2220
KHK 10K 100 RF, PTFE >316L Flange JIS B2220
YY9 Special version, to be specified
60 Electronics
W Prepared for FEI5x
Y Special version, to be specified
1 FEI51; 2-wire 19-253 V AC
2 FEI52; 3-wire PNP, 10 to 55 V DC
3 FEI53; 3-wire, 3 to 12 V signal
4 FEI54; relay DPDT, 19 to 253 V AC, 19 to 55 V DC
5 FEI55; 8/16mA, 11 to 36 V DC
7 FEI57S;2–wire PFM
70 Housing:
1 F15 316L IP66, NEMA4X
2 F16 polyester IP66, NEMA4X
3 F17 aluminum IP66, NEMA4X
4 F13 Alu + gas-tight probe seal IP66, NEMA4X
5 T13 Alu + gas-tight probe seal
+ separate connection compartment
IP66, NEMA4X
9 Special version, to be specified
80 Cable entry:
A Threaded joint M20 (EEx d > M20 thread)
B Thread G ½
C Thread NPT ½
D Thread NPT ¾
Y Special version, to be specified
90 Probe design:
L4: 100 to 6000 mm/12 to 240 inch
1 Compact
2 2000 mm L4 cable > separate housing
3 ....mm L4 cable > separate housing
4 80 inch L4 cable > separate housing
5 ....inch L4 cable > separate housing
9 Special version, to be specified
100 Additional equipment:
A Basic version
D EN10204-3.1 (316L wetted), Inspection certificate
E EN10204-3.1 (316L wetted), NACE
MR0175
Inspection certificate
F SIL Declaration of Conformity
S GL marine approval
Y Special version, to be specified
FTI52 Product designation
* Pending.
50 Process connection: