Liquicap M FTI51, FTI52 Installation
Endress+Hauser 41
3.8.2 Wall mounting
• Push the bracket onto the sleeve and screw it into place.
• Mark the distance between holes on the wall, then drill the holes.
• Screw the separate housing to the wall.
L00-FMI5xxxx-03-05-xx-xx-010
3.8.3 Pipe mounting
• Push the bracket onto the sleeve and screw it into place.
• Screw the separate housing to the pipe (max. 2").
L00-FMI5xxxx-03-05-xx-xx-011
3.9 Post-installation check
After installing the measuring device, carry out the following checks:
• Is the device damaged (visual inspection)?
• Does the device meet the specifications at the measuring point, including process temperature
and pressure, ambient temperature, measuring range etc.?
• Is the process connection tightened with the correct torque?
• Are the measuring point number and labeling correct (visual inspection)?
• Is the measuring device adequately protected from precipitation and direct sunlight?
To Next Page
Loading...
