Endress+Hauser Liquicap M FTI51 - Wiring in Housing T13

Wiring Liquicap M FTI51, FTI52
44 Endress+Hauser
4.3 Wiring in housing T13
To connect the electronic insert to the power supply, proceed as follows:
a. Unscrew the housing cover (1).
b. Remove the cable gland (2) and insert the cable (3).
c. Ground the shield (4) on both sides!
L00-FTI5xxxx-04-06-xx-xx-004
!
Note!
The connection shown under (c.) depends on the type of protection ordered. This illustration shows
the terminal module for EEx d. For connection in a separate connection compartment, the same
connection descriptions apply as for the electronic inserts.
!
Note!
All further steps depend on the specific electronic insert used, and are described on the following
pages:
FEI51→ Page 46
FEI52→ Page 47
FEI53→ Page 48
FEI54→ Page 49
FEI55→ Page 50
FEI57S → Page 51
IS
- Ground
–
+
1
2
a.+b. c.
IS - Ground
–
+
1
2
2
3
1
4
12