Endress+Hauser Liquicap M FTI51 - 4.2 Housing Wiring Procedures

Liquicap M FTI51, FTI52 Wiring
Endress+Hauser 43
4.2 Wiring in housing F16, F15, F17, F13
To connect the electronic insert to the power supply, proceed as follows:
a. Unscrew the housing cover (1).
b. Remove the cable gland (2) and insert the cable (3).
c. Ground the shield (4) on both sides!
L00-FTI5xxxx-04-06-xx-xx-003
!
Note!
All further steps depend on the specific electronic insert used, and are described on the following
pages:
FEI51→ Page 46
FEI52→ Page 47
FEI53→ Page 48
FEI54→ Page 49
FEI55→ Page 50
FEI57S → Page 51
1
4
a. b. c.
2
3
–
+
FEI55
8/16mA
11...36V DC
–
+
7
3
I=16mA
5
12