Endress+Hauser Liquicap M FTI51 - Page 34

Installation Liquicap M FTI51, FTI52
34 Endress+Hauser
FTI52 rope probe with fully insulated inactive length (for mounting nozzles)
L00-FMI5xxxx-11-06-xx-xx-010
3.4.3 Shortening the rope
!
Note!
Refer to the operating manual for the rope shortening kit KA061F/00.
3.4.4 Tensioning weight with bracing
It may be necessary to fasten the probe end if the probe sometimes touches the tank wall or another
part. An anchor hole is provided in the probe weight for this purpose.
The bracing can be attached to the tank wall so that it is either conductive or insulating.
To prevent the danger of a high tensile load, the rope should be loose or braced with a spring. The
maximum tensile load must not exceed 200 N.
L00-FMI5xxxx-11-06-xx-xx-012