Endress+Hauser Micropilot FMR20 HART - System Components; Supplementary Documentation; Brief Operating Instructions (KA); Operating Instructions (BA)

Micropilot FMR20 HART
56 Endress+Hauser
W@M is available:
www.endress.com/lifecyclemanagement
System components
Memograph M graphic data manager
The Memograph M graphic data manager provides information on all the relevant process variables.
Measured values are recorded correctly, limit values are monitored and measuring points analyzed.
The data are stored in the 256 MB internal memory and also on an SD card or USB stick.
For details, see Technical Information TI01180R and Operating Instructions BA01338R
RNS221
Supply unit for powering two 2-wire measuring devices. Bidirectional communication is possible via
the HART communication jacks.
For details, see Technical Information TI00081R and Brief Operating Instructions KA00110R
RN221N
Active barrier with power supply for safe separation of 4 to 20 mA standard signal circuits.
Bidirectional HART communication is possible via integrated communication jacks (R=250 Ω).
For details, see Technical Information TI073R and Operating Instructions BA202R
RMA42
Digital process transmitter for monitoring and displaying analog measured values
For details, see Technical Information TI00150R and Operating Instructions BA00287R
RIA452
RIA452 digital process indicator, panel mounted housing for monitoring and displaying analog
measured values with batch and pump control functions and flow calculation
For details, see Technical Information TI113R and Operating Instructions BA00254R
HAW562
Overvoltage protection device for DIN rail as per IEC 60715, suitable for protecting electronics
against destruction as a result of overvoltage.
For details, see Technical Information TI01012K
Supplementary documentation
The following documentation types are available in the Downloads section of the Endress+Hauser
website (www.endress.com/downloads):
For an overview of the scope of the associated Technical Documentation, refer to the following:
• W@M Device Viewer (www.endress.com/deviceviewer): Enter the serial number from
nameplate
• Endress+Hauser Operations App: Enter the serial number from the nameplate or scan the
2D matrix code (QR code) on the nameplate
Brief Operating Instructions
(KA)
Guide that takes you quickly to the 1st measured value
The Brief Operating Instructions contain all the essential information from incoming acceptance to
initial commissioning.
Operating Instructions (BA)
Your reference guide
These Operating Instructions contain all the information that is required in various phases of the life
cycle of the device: from product identification, incoming acceptance and storage, to mounting,
connection, operation and commissioning through to troubleshooting, maintenance and disposal.
Safety Instructions (XA)
Depending on the approval, the following Safety Instructions (XA) are supplied with the device. They
are an integral part of the Operating Instructions.
The nameplate indicates the Safety Instructions (XA) that are relevant to the device.