Micropilot FMR67B PROFINET with Ethernet-APL Mounting
Endress+Hauser 19
5.3.4 Antenna, flush mount 80 mm (3 in)
Information about the mounting nozzle
The maximum nozzle length H
max
depends on the nozzle diameter D.
Antenna nozzle mounting, flush mount 80 mm (3 in)
ØD H
max
80 to 100 mm (3.2 to 4 in) 1 750 mm (70 in)
100 to 150 mm (4 to 6 in) 2 200 mm (88 in)
≥ 150 mm (6 in) 3 300 mm (132 in)
In the case of longer nozzles, reduced measuring performance must be expected.
Please note the following:
• The end of the nozzle must be smooth and free from burrs.
• The edge of the nozzle should be rounded.
• Mapping must be performed.
• Please contact the manufacturer's support department for applications with nozzles
that are higher than indicated in the table.
5.3.5 Antenna flush mount 80 mm (3 in) with alignment unit
UNI flanges with an integrated alignment unit are available for the antenna flush mount
80 mm (3 in). An inclination of the antenna axis of up to 15 ° in all directions can be set
with the help of the alignment unit. The alignment unit is used to optimally align the
measuring signal to the bulk solids.
A0046592
3 Antenna flush mount with alignment unit
Information about the mounting nozzle
The maximum nozzle length H
max
depends on the nozzle diameter D.
To Next Page
Loading...
