Endress+Hauser NRF81 - Page 127

Tankside Monitor NRF81 Operating menu
Endress+Hauser 127
Operating mode 
Navigation  Setup → Advanced setup → Input/output → HART devices → HART Device(s)
→ Operating mode
Prerequisite Not available if the HART device is a Prothermo NMT.
Description Selection of the operation mode PV only or PV,SV,TV,QV. Devines which values are polled
from the connected HART Device.
Selection • PV only
• PV,SV,TV & QV
• Level
4)
• Measured level
4)
Factory setting PV,SV,TV & QV
Additional information
Read access Operator
Write access Maintenance
Communication status
Navigation  Setup → Advanced setup → Input/output → HART devices → HART Device(s)
→ Communication status
Description Shows the operating status of the transmitter.
User interface • Operating normally
• Device offline
Additional information
Read access Operator
Write access -
#blank# ( HART PV - designation dependent on device)
Navigation  Setup → Advanced setup → Input/output → HART devices → HART Device(s)
→ #blank#
Description Shows the first HART variable (PV).
Additional information
Read access Operator
Write access -
4) only visible if the conneced device is a Micropilot