Endress+Hauser NRF81 - Page 129

Tankside Monitor NRF81 Operating menu
Endress+Hauser 129
Description Defines which HART variable is the pressure.
Selection • No value
• Primary variable (PV)
• Secondary variable (SV)
• Tertiary variable (TV)
• Quaternary variable (QV)
Factory setting No value
Additional information
Read access Operator
Write access Maintenance
Output density 
Navigation  Setup → Advanced setup → Input/output → HART devices → HART Device(s)
→ Output density
Prerequisite Not available for Micropilot S FMR5xx and Prothermo 53x. (In these cases the measured
variables are allocated automatically).
Description Defines which HART variable is the density.
Selection • No value
• Primary variable (PV)
• Secondary variable (SV)
• Tertiary variable (TV)
• Quaternary variable (QV)
Factory setting No value
Additional information
Read access Operator
Write access Maintenance
Output temperature 
Navigation  Setup → Advanced setup → Input/output → HART devices → HART Device(s)
→ Output temperature
Prerequisite Not available for Micropilot S FMR5xx and Prothermo 53x. (In these cases the measured
variables are allocated automatically).
Description Defines which HART variable is the temperature.
Selection • No value
• Primary variable (PV)
• Secondary variable (SV)
• Tertiary variable (TV)
• Quaternary variable (QV)