Endress+Hauser NRF81 - Page 133

Tankside Monitor NRF81 Operating menu
Endress+Hauser 133
Selection • Cu50 (w=1.428, GOST)
• Cu53 (w=1.426, GOST)
• Cu90@0°C (w=1.4274, GOST)
• Cu100@25°C (w=1.4274, GOST)
• Cu100@0°C(w=1.4274, GOST)
• Pt46 (w=1.391, GOST)
• Pt50 (w=1.391, GOST)
• Pt100(385) (a=0.00385, IEC751)
• Pt100(389) (a=0.00389, Canadian)
• Pt100(391) (a=0.003916, JIS1604)
• Pt100 (w=1.391, GOST)
• Pt500(385) (a=0.00385, IEC751)
• Pt1000(385) (a=0.00385, IEC751)
• Ni100(617) (a=0.00617, DIN43760)
• Ni120(672) (a=0.00672, DIN43760)
• Ni1000(617) (a=0.00617, DIN43760)
Factory setting Pt100(385) (a=0.00385, IEC751)
Additional information
Read access Operator
Write access Maintenance
RTD connection type 
Navigation  Setup → Advanced setup → Input/output → Analog IP → RTD connection type
Prerequisite Operating mode (→  132) = RTD temperature input
Description Defines the connection type of the RTD.
Selection • 4 wire RTD connection
• 2 wire RTD connection
• 3 wire RTD connection
Factory setting 4 wire RTD connection
Additional information
Read access Operator
Write access Maintenance
Process value
Navigation  Setup → Advanced setup → Input/output → Analog IP → Process value
Prerequisite Operating mode (→  132) ≠ Disabled
Description Shows the measured value received via the analog input.