Endress+Hauser NRF81 - Page 157

Tankside Monitor NRF81 Operating menu
Endress+Hauser 157
"Configuration" submenu
This submenu is only present for devices with a V1 communication interface.
Navigation  Setup → Advanced setup → Communication → V1 X1-4
→ Configuration
Communication interface protocol variant 
Navigation  Setup → Advanced setup → Communication → V1 X1-4 → Configuration
→ Communication interface protocol variant
Description Determines which variant of the V1 protocol is used.
Selection • None
• V1
Factory setting None
Additional information
Read access Operator
Write access Maintenance
V1 address 
Navigation  Setup → Advanced setup → Communication → V1 X1-4 → Configuration → V1
address
Prerequisite Communication interface protocol variant (→  157) = V1
Description Identifier of the device for the V1 communication.
User entry 0 to 99
Factory setting 1
Additional information
Read access Operator
Write access Maintenance
V1 address 
Navigation  Setup → Advanced setup → Communication → V1 X1-4 → Configuration → V1
address
Prerequisite Communication interface protocol variant (→  157)
Description Identifier of the previous device for V1 communication.