Endress+Hauser NRF81 - Page 172

Operating menu Tankside Monitor NRF81
172 Endress+Hauser
"Application" submenu
Navigation  Setup → Advanced setup → Application
"Tank configuration" submenu
Navigation  Setup → Advanced setup → Application → Tank configuration
"Level" submenu
Navigation  Setup → Advanced setup → Application → Tank configuration
→ Level
Level source 
Navigation  Setup → Advanced setup → Application → Tank configuration → Level → Level
source
Description Defines the source of the level value.
Selection • No input value
• HART device 1 ... 15 level
• Level SR
*
• Level
*
• Displacer position
*
• AIO B1-3 value
• AIO C1-3 value
• AIP B4-8 value
• AIP C4-8 value
Factory setting Dependent on the device version
Additional information
Read access Operator
Write access Maintenance
Operation mode 
Navigation  Setup → Advanced setup → Application → Tank configuration → Level → Operation
mode
Description Selection of normal or HTG mode for level measurement . In the HTG mode, the level is
calculated using a pressure device.
* Visibility depends on order options or device settings