Endress+Hauser NRF81 - Page 181

Tankside Monitor NRF81 Operating menu
Endress+Hauser 181
"Pressure" submenu
Navigation  Setup → Advanced setup → Application → Tank configuration
→ Pressure
P1 (bottom) source 
Navigation  Setup → Advanced setup → Application → Tank configuration → Pressure → P1
(bottom) source
Description Defines the source of the bottom pressure (P1).
Selection • Manual value
• HART device 1 ... 15 pressure
• AIO B1-3 value
• AIO C1-3 value
• AIP B4-8 value
• AIP C4-8 value
Factory setting Manual value
Additional information
Read access Operator
Write access Maintenance
P1 (bottom)
Navigation  Setup → Advanced setup → Application → Tank configuration → Pressure → P1
(bottom)
Description Shows the pressure at the tank bottom.
Additional information
Read access Operator
Write access -
P1 (bottom) manual pressure 
Navigation  Setup → Advanced setup → Application → Tank configuration → Pressure → P1
(bottom) manual pressure
Prerequisite P1 (bottom) source (→  181) = Manual value
Description Defines the manual value of the bottom pressure (P1).
User entry –25 to 25 bar