Endress+Hauser NRF81 - Page 182

Operating menu Tankside Monitor NRF81
182 Endress+Hauser
Factory setting 0 bar
Additional information
Read access Operator
Write access Maintenance
P1 position 
Navigation  Setup → Advanced setup → Application → Tank configuration → Pressure → P1
position
Description Defines the position of the bottom pressure transmitter (P1), measured from zero position
(tank bottom or datum plate).
User entry –10 000 to 100 000 mm
Factory setting 5 000 mm
Additional information
Read access Operator
Write access Maintenance
P1 offset 
Navigation  Setup → Advanced setup → Application → Tank configuration → Pressure → P1
offset
Description Offset for the bottom pressure (P1). The offset is added to the measured pressure prior to
any tank calculation.
User entry –25 to 25 bar
Factory setting 0 bar
Additional information
Read access Operator
Write access Maintenance
P1 absolute / gauge 
Navigation  Setup → Advanced setup → Application → Tank configuration → Pressure → P1
absolute / gauge
Description Defines whether the connected pressure transmitter measures an absolute or a gauge
pressure.
Selection • Absolute
• Gauge