Tankside Monitor NRF81 Operating menu
Endress+Hauser 217
Alarm value source
Navigation Setup → Advanced setup → Application → Alarm → Alarm → Alarm value source
Prerequisite Alarm mode (→ 215) ≠ Off
Description Determines the process variable to be monitored.
Selection • Tank level
• Liquid temperature
• Vapor temperature
• Water level
• P1 (bottom)
• P2 (middle)
• P3 (top)
• Observed density value
• Volume
• Flow velocity
• Volume flow
• Vapor density
• Middle density
• Upper density
• Correction
• Tank level %
• GP 1...4 value
• Measured level
• P3 position
• Tank reference height
• Local gravity
• P1 position
• Manual density
• Tank ullage
• Average profile density
• Lower density
• Upper interface level
• Lower interface level
• Bottom level
• Displacer position
• HART device 1...15 PV
• HART device 1...15 SV
• HART device 1...15 TV
• HART device 1...15 QV
• HART device 1...15 PV mA
• HART device 1...15 PV %
• Element temperature 1...24
• AIO B1-3 value
• AIO C1-3 value
• AIP B4-8 value
• AIP C4-8 value
• None
Factory setting None
Additional information
Read access Operator
Write access Maintenance
To Next Page
