Endress+Hauser Proline Prosonic Flow P 500 - Page 21

Proline Prosonic Flow P 500 HART Use in protective systems
Endress+Hauser 21
Setup
Current output 1
Assign
current output
=
Volume flow
A0025650-EN
Simulation
=
Off
Diagnostics
Simulation
current output 1
=
Off
Assign
process variable
A0021506-EN
The diagnostic behavior is set in such a way that the measuring device is set to the safe state
when an error occurs. This means that the diagnostic messages listed in the graphic are set to
alarm and the current output adopts the configured failsafe mode →  17.