Endress+Hauser Proline Prowirl 73 - Page 10

Proline Prowirl 73 F, W
10 Endress+Hauser
Piping insulation
When insulating, please ensure that a sufficiently large area of the housing support is exposed. The uncovered
part serves as a radiator and protects the electronics from overheating (or undercooling).
The maximum insulation height permitted is illustrated in the diagrams. These apply equally to both the
compact version and the sensor in the remote version.
A0001868
1 = Flanged version
2 = Wafer version
Wafer version mounting set
The centering rings supplied with the wafer style meters are used to mount and center the instrument.
A mounting set consisting of tie rods, seals, nuts and washers can be ordered separately.
F06-7xxxxxxx-09-00-06-xx-000
Mounting wafer version
1 = Nut
2 = Washer
3 = Tie rod
4 = Centering ring (is supplied with the device)
5 = Seal
12
Esc
E
- +
Esc
E
- +
1
2
3
4
5