EA01018D
Endress+Hauser 7
• If spacing is reduced or the dielectric strength of the measuring device cannot be
guaranteed during repair work, perform a test on completion of the work (e.g. high-voltage
test in accordance with the manufacturer's instructions).
• Service plug:
• Do not connect in explosive atmospheres.
• Only connect to Endress+Hauser service devices.
• Observe the instructions for transporting and returning the device outlined in the Operating
Instructions.
If you have any questions, please contact your Endress+Hauser service organization.
5 Symbols used
5.1 Symbols for certain types of information
Symbol Meaning
Permitted
Procedures, processes or actions that are permitted.
Forbidden
Procedures, processes or actions that are forbidden.
Tip
Indicates additional information.
,
,
… Series of steps
6 Tools list
Allen key
3 mm
Torx screwdriver
T8, T20, T20
Phillips screwdriver
PH2
Slotted head
screwdriver
0.5 × 3.5 mm
Hexagon wrench
8 mm
Wire cutter
To Next Page
Loading...
