Endress+Hauser Proservo NMS80 User Manual

Proservo NMS80 Electrical connection
Endress+Hauser 41
6.2 Connecting requirements
6.2.1 Cable specification
Terminals
Wire cross section 0.2 to 2.5 mm
2
(24 to 13 AWG)
Use for terminals with function: Signal and power supply
• Spring terminals (NMx8x-xx1...)
• Screw terminals (NMx8x-xx2...)
Wire cross section max. 2.5 mm
2
(13 AWG)
Use for terminals with function: Ground terminal in the terminal compartment
Wire cross section max. 4 mm
2
(11 AWG)
Use for terminals with function: Ground terminal at the housing
Power supply line
Standard device cable is sufficient for the power line.
HART communication line
• Standard device cable is sufficient if only the analog signal is used.
• Shielded cable is recommended if using the HART protocol. Observe the grounding concept
of the plant.
Modbus communication line
• Observe the cable conditions from the TIA-485-A, Telecommunications Industry
Association.
• Additional conditions: Use shielded cable.
V1 communication line
• 2-wire twisted pair, screened or unscreened cable
• Resistance in one cable: ≤ 120 Ω
• Capacitance between lines: ≤ 0.3 µF

Endress+Hauser Proservo NMS80 Specifications

General

Brand	Endress+Hauser
Model	Proservo NMS80
Category	Measuring Instruments
Language	English