Safety instructions Soliswitch FTE20
6 Endress+Hauser
2 Safety instructions
2.1 Requirements for the personnel
The personnel for installation, commissioning, diagnostics and maintenance must fulfill the
following requirements:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task.
‣
Are authorized by the plant owner/operator.
‣
Are familiar with federal/national regulations.
‣
Before starting work, read and understand the instructions in the manual and
supplementary documentation as well as the certificates (depending on the application).
‣
Follow instructions and comply with basic conditions.
The operating personnel must fulfill the following requirements:
‣
Are instructed and authorized according to the requirements of the task by the facility's
owner-operator.
‣
Follow the instructions in this manual.
2.2 Intended use
The Soliswitch FTE20 must only be used as a point level switch for specific bulk solids (see
Technical data → 26).
• The device may only be operated when installed.
• The manufacturer accepts no liability for damages resulting from improper or non-
designated use. It is not permitted to convert or modify the device in any way.
2.3 Workplace safety
When working on and with the device:
‣
Wear the required personal protective equipment as per national regulations.
2.4 Operational safety
Risk of injury!
‣
Operate the device only if it is in proper technical condition, free from errors and faults.
‣
The operator is responsible for ensuring trouble-free operation of the device.
Modifications to the device
Unauthorized modifications to the device are not permitted and can lead to unforeseeable
dangers:
‣
If modifications are nevertheless required, consult with Endress+Hauser.
To Next Page
Loading...
