Endress+Hauser Soliswitch FTE20 - Installation Conditions

Mounting Soliswitch FTE20
8 Endress+Hauser
4.1.2 Transport and storage
Please note the following:
• Pack the device so that is protected against impact for storage and transport. The original
packaging offers the best protection for this.
• The permitted storage temperature is –20 to 60 °C (–4 to 140 °F).
4.2 Installation conditions
Correct and incorrect installation positions are indicated in →  2,  8.
The device must be protected against direct sunshine. A weather protection cover is available
as an accessory, see the "Accessories" section →  30.
The dimensions of the device are provided in the "Technical data" section →  16,  27.
1
3
2
4
~200 (7.87)
5
6
7
8
A0021567
 2 Orientations of the point level switch, dimensions in mm (in)
Permitted orientations Forbidden orientations
1: Vertical from the top 6: In direction of solids flow
2: Angled from the top 7: Installation coupling too long
3: From the side 8: Horizontal with shaft length >300 mm (11.8 in)
4: From the side with protective cover against falling
solids
5: From the bottom (device must be protected
against shock-type loads)
Ambient temperature range
–20 to 60 °C (–4 to 140 °F)
Medium temperature range
–20 to 80 °C (–4 to 176 °F)