3. In the Networking tab, click Internet Protocol Version 4 (TCP/IPv4), and then click
Properties.
4. In the properties dialog box, click Use the following IP address: to configure your
computer for Static TCP/IP. Enter an IP address (i.e. 192.168.1.10), the subnet mask of the
ENH210, and the default gateway which is the ENH210’s IP address, 192.168.1.1. Note: the
subnet mask must match that of the ENH210 and the IP address must be on that subnet.
5. Click the OK button to save your changes and close the dialog box.
6. Click the OK button again to save your changes.
To Next Page
Loading...
