13
Operating Instructions
Remote Flame Control
The Proame 2 GTMF has six (6) ame levels. With the system on, and the ame level at the maximum in the
appliance, pressing the Down Arrow Key once will reduce the ame height by one step until the ame is turned off.
The Up Arrow Key will increase the ame height each time it is pressed. If the Up Arrow Key is pressed while the
system is on but the ame is off, the ame will come on in the high position (refer to Figure 11 below). A single “beep”
will conrm reception of the command.
Figure 11: Remote Control’s Flame Levels.
Flame Off
Flame Level 1
Flame Level 5
Maximum Flame Level
Flame Off
Flame Level 1
Flame Level 5
Maximum Flame Level
Fan Control
The EX32 comes with a convection fan that can be
controlled with the Transmitter. The fan speed can be
adjusted thorugh six (6) speeds. To control the fan
press the MODE key (Figure 5) to index to the fan
control icon (Figure 12). Use the UP/DOWN arrow
keys to turn on, off, or adjust the fan speed (Figure
12). A single beep from the IFC will conrm the
command has been received
Figure 12: Fan Control
Figure 13: Bottom Light Control
Ember Lights Control
The ember lights at the front of the replace can
be controlled with the Transmitter. The lights can
be adjusted thorugh six (6) levels. To adjust the
brightness of the lights press the MODE key (Figure
5) to index to the light control icon (Figure 13). Use
the UP/DOWN arrow keys to turn on, off, or adjust
the brightness (Figure 13). A single beep from the
IFC will conrm the command has been received.
To Next Page
Loading...
Need help?
General
