13
Installation
gas Flex line installation
With the unit now properly secured to the suspension structure, the supplied 4ft long gas ex line can routed
and connected.
1. Lift the S50 top plate to access the bottom area of the suspension structure. The Duravent slip section also
will need to be lifted to complete the gas connection.
2. Route the supplied ex line down the left side of the S50 cabinet back as shown in the pictures below. Re-
moval of the cabinet back will improve the ease of installation but is not required:
3/8 NPT tting. Connect to incoming
copper line.
Conrm ex line is not pinched when
slip section is lowered back down
IMPORTANT - Flex line must be clear of relief plate.
Correct ex line routing with top plate
in position
Figure 13: Flex Line Installation - Step 1
Figure 14: Flex Line Installation - Step 2
Figure 15: Flex Line Installation - Step 3
To Next Page
Loading...
