14
Installation
3. Disconnect the 10” long factory ex line
from the outlet side of the SIT gas valve and
discard.
4. Install the supplied 3/8 to 1/2 brass adaptor
tting and connect the other end of the new
4ft ex line to the SIT gas valve as shown:
Figure 18: Fan Cover Installation
inCoMing PoWer installation
1. Lift the S50 top plate to access the
bottom area of the suspension struc-
ture. The Duravent slip section can
also be lifted to provide better access.
Find the high-temp wires and gas line
and thread them through the brace
cutout shown in Figure 17.
2. Run the incoming power down the
right side of the cabinet back and into
the electrical component area. Re-
moval of the cabinet back will improve
ease of installation but is not required.
Incoming
120VAC
Power Line
Figure 16: Flex Line Installation - Step 4
With the installation of the gas ex line
complete the incoming power wire can be
routed and properly connected.
3. Disconnect the main power cord from the socket on the back to provide a ush surface for the cabinet back
to reattach. Refer to section “Relocating Gas/Electrical” in the Owner’s manual for more details.
*Note: You
do not need to move the adapters to their new, bottom facing positions as described in this section
.
Figure 17: Routing Incoming Power
4. The new incoming power wires will need to be joined
to the electrical circuit of the unit. This will vary based
on the version of S50 being used. Refer to the electrical
diagram in the Owner’s Manual for your unit and join the
wires where the power cord is shown within the circuit.
5. Retrieve the fan cover included with the starter kit and
attach it to the bottom of the unit using four (4) #8 T20
screws as shown in Figure 18.
To Next Page
Loading...
